-40%

03 04 05 06 07 08 FORD 6.0 DIESEL FICM REPAIR SERVICE TO YOUR UNIT

$ 118.8

Availability: 23 in stock
  • Returns Accepted: ReturnsNotAccepted
  • Condition: Remanufactured

    Description

    This is a REPAIR SERVICE to your part.
    We do not stock this item for sale.
    If you purchase this listing, we will be fixing YOUR unit.
    YOU MUST SEND YOUR FICM TO US SO WE CAN REBUILD IT FOR YOU.
    ********Please disregard the estimated shipping time that we have listed on this repair**********
    Ebay’s new handling time policy does not give sufficient time for the actual shipping time that it takes for you to ship your unit to us and for us to repair it and ship it back.
    We would be penalizes for appearing to have slow shipping and handling time regardless of the fact that we do not offer slow S&H.
    Subsequently, we have to enter an outrageous long handling time so we meet the handling time policy and maintain the Trusted and Great seller title.
    In our actual handling time procedure, once we receive your item it is repaired the SAME DAY or THE FOLLOWING day. One to two day turn-around, then we ship the item back to you right away.
    ******************************************************************************************************************************
    ·
    THIS REPAIR SERVICE TO YOUR FICM WILL COVER THE FOLLOWING VECHICLES LISTED BELOW Equipped with a International Module:
    2003 to 2005 FORD EXCURSION
    2003 TO 2007 F250 SUPER DUTY
    2003 TO 2007 F350 SUPER DUTY
    2003 ONLY F450 AND F550
    2004 TO 2009 FORD VAN
    This module fails causing problems with your Truck, P0611 code.
    This error code can also trigger low voltage on the injectors causing the P0261, P0264, P0267, P0270, P0273, P0276, P0279 & P0282 codes
    ,,,, like not to start or slow cold start and very poor fuel economy and power loss…if this is so, then your FICM (Fuel Injection Control Module) is more than likely bad and needs to be repaired…
    REMEMBER THAT THIS IS NOT A CHEAP REBUILT BUT IT IS A COMPLETE ONE
    HOW TO TEST YOUR FICM
    On top of the FICM you will see small rectangular plate with 2 T20 torx screws.
    Remove them and pull the plate off,,, YOU MUST ONLY TOUCH THE SCREW CLOSET TO THE DRIVER SIDE,
    AND
    BE VERY CAREFUL NOT TO TOUCH ANYTHING ELSE WITH YOUR METER LEAD…,
    check that screw (DC Voltage) to battery ground, you should measure 45 volts or above , If the voltage measured is less than 45 volts then your FICM needs repair…
    WE ARE SO CONFIDENT IN OUR REBUILD SERVICE AND THE REPLACEMENT COMPONENTS WE USE, THAT WE INCLUDE OUR ONE YEAR WARRANTY WITH EACH REBUILD SERVICE
    OUR UNIT WILL BE SHIPPED BACK TO YOU WITHIN 24 HRS
    ONE YEAR WARRANTY AS LONG AS YOU OWN THE CAR
    EBAY'S NEW POLICY DOES NOT ALLOW US TO GIVE OUT OUR ADDRESS OR PHONE NUMBER. ONCE YOU BUY THE REPAIR SERVICE AND YOU HAVE PAID FOR IT, WE WILL SEND YOU AN EMAIL WITH THE ADDRESS WHERE TO SHIP THE UNIT. THANKS
    DIGITAL AUTO TECHNOLOGY RIVERSIDE CA.
    We only ship to Continental United States.
    Please do not purchase this item if you are not in the United States.
    Thank You